The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
This DTC is stored when the skid control ECU (brake actuator assembly) detects improper installation of the yaw rate and acceleration sensor (airbag sensor assembly) or an abnormality in the difference between the yaw rate sensor (airbag sensor assembly) value and the control value estimated based on the acceleration sensor (airbag sensor assembly), steering angle sensor and speed sensor signals.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C124F62 | Yaw Rate Sensor Signal Compare Failure | A yaw rate sensor (airbag sensor assembly) comparison malfunction status continues. | ·
Yaw rate sensor (airbag sensor assembly) installation ·
Yaw rate sensor (airbag sensor assembly) |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform "Calibration" after performing "Reset Memory".
Start the engine.
Perform a road test.
Check the yaw rate sensor (airbag sensor assembly) output value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Yaw Rate Sensor Value | Yaw rate sensor (airbag sensor assembly) | Min.: -128°/s
Max.: 127°/s |
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s Turning left: 0 to 127°/s |
- |
| Tester Display |
|---|
| Yaw Rate Sensor Value |
| Result | Proceed to |
|---|---|
| NG (The yaw rate sensor (airbag sensor assembly) output value is 0°/s when the vehicle is stationary, but the value fluctuates when turning.) | A |
| NG (The yaw rate sensor (airbag sensor assembly) output value is not 0°/s when the vehicle is stationary.) | B |
| OK | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the ignition switch off.
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.
The yaw rate and acceleration sensor (airbag sensor assembly) is not installed in a tilted position.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION