| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13B800 | Electric Parking Brake Actuator | ·
Diagnosis Condition: Electric parking brake operating ·
Malfunction Status: Repeated slipping is detected ·
Detection Time: - |
·
Parking brake actuator assembly ·
Rear brake |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
Although DTC C13B800 may be stored after entering pad replacement mode, this is not a malfunction.
Although DTC C13B800 may be stored after forcibly releasing the parking brake, this is not a malfunction.
To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.
After replacing the No. 2 skid control ECU (brake actuator assembly), perform calibration (linear solenoid valve offset learning, SM solenoid valve offset learning, brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration) after performing "Reset Memory".
When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.
Using the GTS, check for DTCs other than DTC C13B800.
| Result | Proceed to |
|---|---|
| Only DTC C13B800 is output | A |
| DTCs other than C13B800 are output | B |
A
B
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (for HV Model)>DIAGNOSTIC TROUBLE CODE CHART
Lift the vehicle and check the status of the rear wheels using the GTS when the electric parking brake is applied and released.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE ACTUATOR>ON-VEHICLE INSPECTION
| Proceed to |
|---|
| NEXT |
NEXT