Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM (for HV Model)
RM37A0E _54 Brake _086873 PARKING BRAKE _0420958 ELECTRIC PARKING BRAKE SYSTEM(for HV Model) J

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM(for HV Model)  Message Not Displayed on Multi-information Display When AUTO Function Set to ON/OFF  


DESCRIPTION

When the AUTO function is set to ON/OFF, a message is displayed on the multi-information display in the combination meter assembly.

WIRING DIAGRAM

C403409E12
1.177,0.583 4.75,1 3.573,0.417 10 false No. 2 Skid Control ECU (Brake Actuator Assembly) 1.167,0.979 4.49,1.417 3.323,0.438 10 false - Multi-information Display Request Signal 1.177,2.583 4.5,3.021 3.323,0.438 10 false Combination Meter Assembly 1.177,2.979 4.5,3.417 3.323,0.438 10 false - Multi-information Display 0.844,4.156 4.167,4.594 3.323,0.438 10 false : CAN Communication Line

CAUTION / NOTICE / HINT

NOTICE:
·

To ensure that the electric parking brake does not operate, wait for 3 minutes or more with the ignition switch off, the driver door closed, and the brake pedal not depressed, then disconnect each connector, fuse and relay.

·

After replacing the No. 2 skid control ECU (brake actuator assembly), perform calibration (linear solenoid valve offset learning, SM solenoid valve offset learning, brake pedal stroke sensor assembly zero point calibration, system information memorization, and yaw rate and acceleration sensor zero point calibration) after performing "Reset Memory".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY

·

When replacing the No. 2 skid control ECU (brake actuator assembly), operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light (red) blinks when the ignition switch is first turned ON.



PROCEDURE

1.CHECK OPERATION OF AUTO FUNCTION
a.

Check that the AUTO function operates when the operating conditions are met.

HINT:

Do not use the multi-information display to determine whether the AUTO function is operating or not.



Result:
Result Proceed to
The AUTO function operates A
The AUTO function does not operate B



A

REPLACE COMBINATION METER ASSEMBLY

B