Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) G

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK

a.

When the ignition switch is turned to ON, check that the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator), VSC OFF indicator light, slip indicator light, brake hold standby indicator light and brake hold operated indicator light come on for approximately 3 seconds.

HINT:
·

When the brake fluid level is low, the brake system warning light (red indicator) comes on.

·

If the skid control ECU stores any DTCs, the ABS warning light, brake system warning light (red indicator), brake system warning light (yellow indicator) and slip indicator light will come on. Also, in this state, if the vehicle is under the following conditions and the brake hold switch (electric parking brake switch assembly) is turned on, the brake hold operated indicator light blinks.

Vehicle Conditions:

(1)

The driver door is closed.

(2)

The driver seat belt is fastened.



·

If the warning lights and indicator lights does not illuminate or illuminates for more than approximately 3 seconds, perform troubleshooting for the electronically controlled brake system.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>HOW TO PROCEED WITH TROUBLESHOOTING