The brake pedal stroke sensor assembly sends a signal about the pedal stroke to the skid control ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C110000 | Brake Pedal Position Sensor "A" Supply Voltage Malfunction | When the voltage at terminal +BI1 is 7.3 V or more, the value of brake pedal stroke sensor 1 is invalid for 0.2 seconds or more. | ·
Wire harness and connector ·
Brake pedal stroke sensor assembly |
Output ECU: No. 1 skid control ECU (brake booster with master cylinder assembly) |
After replacing or reinstalling the brake pedal stroke sensor assembly, perform "Calibration".
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
The connector is securely connected.
Disconnect the A44 No. 1 skid control ECU (brake booster with master cylinder assembly) connector.
Disconnect the A43 brake pedal stroke sensor assembly connector.
Check both the connector case and the terminals for deformation and corrosion.
No deformation or corrosion.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A44-3 (SKS1) - A43-6 (SKS1) | Always | Below 1 Ω |
| A44-3 (SKS1) or A43-6 (SKS1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG