Stop the vehicle on a level surface.
1.INSPECT DIFFERENTIAL OIL (for Dynamic Torque Control AWD)
Using a 10 mm hexagon socket wrench, remove the rear differential filler plug and gasket.
| *a | 0 to 5 mm (0 to 0.196 in.) |
Check that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the rear differential filler plug opening.
If there is not enough oil, inspect for oil leaks and fill the rear differential carrier assembly with Toyota genuine differential gear oil LX.
Add the differential oil in small quantities every few minutes.
Too much or too little oil will lead to differential problems.
Using a 10 mm hexagon socket wrench, install a new gasket and the rear differential filler plug.
After changing the oil, drive the vehicle and then check the oil level again.
2.INSPECT DIFFERENTIAL OIL (for Dynamic Torque Vectoring AWD)
Using a 10 mm hexagon socket wrench, remove the rear differential filler plug and gasket.
| *a | 0 to 5 mm (0 to 0.196 in.) |
Check that the oil level is between 0 to 5 mm (0 to 0.196 in.) from the bottom lip of the rear differential filler plug opening.
If there is not enough oil, inspect for oil leaks and fill the torque vectoring differential carrier assembly with Toyota genuine differential gear oil LX.
Add the differential oil in small quantities every few minutes.
Too much or too little oil will lead to differential problems.
Using a 10 mm hexagon socket wrench, install a new gasket and the rear differential filler plug.
After changing the oil, drive the vehicle and then check the oil level again.