| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory |
|---|---|---|---|---|---|
| C13FB00 | 4WD/AWD Front/Rear Disconnect System Stuck ON | The following conditions occur 5 times or more in succession:
·
When changing from connected to disconnected, the rotation speed of the rear ring gear does not change to 0 rpm for 6 seconds or more |
·
Front 4WD linear solenoid (transfer assembly) ·
Rear 4WD linear solenoid (rear differential carrier assembly) |
Displayed | Yes |
After performing repairs, clear the DTCs and check that the DTCs are not output again.
Click hereDrivetrain>GF2A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE CONTROL AWD SYSTEM>DTC CHECK / CLEAR
Lift the vehicle.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Rear Ring Gear Revolution | Rear ring gear revolution | Min.: 0.00 rpm
Max.: 3199.95 rpm |
- | - |
| Tester Display |
|---|
| Rear Ring Gear Revolution |
While using both hands to simultaneously rotate both rear wheels in the forward direction, observe the value of the Data List item.
The value of Data List item "Rear Ring Gear Revolution" is 0 rpm.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Lift the vehicle.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Rear Ring Gear Revolution | Rear ring gear revolution | Min.: 0.00 rpm
Max.: 3199.95 rpm |
- | - |
| Tester Display |
|---|
| Rear Ring Gear Revolution |
While using both hands to simultaneously rotate both front wheels in the forward direction, observe the value of the Data List item.
The value of Data List item "Rear Ring Gear Revolution" is 0 rpm.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG