| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory |
|---|---|---|---|---|---|
| C13F700 | 4WD/AWD Front Disconnect System Performance | Any of the following conditions occur a total of 5 times consecutively:
·
After switching from disengaged to engaged, the No. 1 4 wheel drive position switch does not indicate engaged for 6 seconds continuously. ·
After switching from engaged to disengaged, the No. 1 4 wheel drive position switch does not indicate disengaged for 5 seconds continuously. ·
When there is no request to change state, the No. 1 4 wheel drive position switch changes to another state for 60 seconds continuously. |
·
Front 4WD linear solenoid (transfer assembly) ·
No. 1 4 wheel drive position switch |
Displayed | Yes |
| Vehicle Condition | |||||
|---|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | Pattern 4 | ||
| Diagnosis Condition | When switching from disengaged to engaged | ○ | - | - | - |
| When switching from engaged to disengaged | - | ○ | - | - | |
| Disengaged | - | - | ○ | - | |
| Engaged | - | - | - | ○ | |
| Malfunction Status | The No. 1 4 wheel drive position switch does not indicate engaged for 6 seconds continuously | ○ | - | - | - |
| The No. 1 4 wheel drive position switch does not indicate disengaged for 5 seconds continuously | - | ○ | - | - | |
| The No. 1 4 wheel drive position switch changes to another state for 60 seconds continuously. | - | - | ○ | ○ | |
| Detection Time | Any malfunction status occur a total of 5 times consecutively | ||||
| Number of Trips | - | ||||
DTC will be stored when conditions for either of the patterns in the table above are met.
After performing repairs, clear the DTCs and check that the DTCs are not output again.
Click hereDrivetrain>GF2A (TRANSFER / 4WD / AWD)>DYNAMIC TORQUE VECTORING AWD SYSTEM>DTC CHECK / CLEAR
Check whether DTCs other than C13F700 are output.
| Result | Proceed to |
|---|---|
| Only DTC C13F700 is output. | A |
| DTC C13F700 and C05E01C are output. | B |
A
B