Home › Drivetrain › GF2A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE VECTORING AWD SYSTEM
RM37A0E _52 Drivetrain _086861 GF2A TRANSFER / 4WD / AWD _0421156 DYNAMIC TORQUE VECTORING AWD SYSTEM C

GF2A TRANSFER / 4WD / AWD  DYNAMIC TORQUE VECTORING AWD SYSTEM  U010087  Lost Communication with ECM/PCM "A" Missing Message  U012587  Lost Communication with Multi-axis Acceleration Sensor Module Missing Message  U012687  Lost Communication with Steering Angle Sensor Module Missing Message  U012987  Lost Communication with Brake System Control Module Missing Message  U013187  Lost Communication With Power Steering Control Module Missing Message  


DESCRIPTION

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory
U010087 Lost Communication with ECM/PCM "A" Missing Message

When both of the following continue for 2 seconds or more:

-

The voltage of the IG1 terminal is 10 V or more.


-

At a vehicle speed of 60 km/h (38 mph) or more, communication with the ECM cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

ECM


Displayed Yes
U012587 Lost Communication with Multi-axis Acceleration Sensor Module Missing Message

When both of the following continue for 1 second or more:

-

The voltage of the IG1 terminal is 10 V or more.


-

At a vehicle speed of 60 km/h (38 mph) or more, communication with the yaw rate and acceleration sensor (airbag sensor assembly) cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

Yaw rate and acceleration sensor (airbag sensor assembly)


Displayed Yes
U012687 Lost Communication with Steering Angle Sensor Module Missing Message

When both of the following continues for 1 second or more:

-

The voltage of the IG1 terminal is 10 V or more.


-

Communication with the skid control ECU (brake actuator assembly) cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

Steering sensor


Displayed Yes
U012987 Lost Communication with Brake System Control Module Missing Message

When both of the following continue for 3 seconds or more:

-

The voltage of the IG1 terminal is 10 V or more.


-

Communication with the skid control ECU (brake actuator assembly) cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

Skid control ECU (Brake actuator assembly)


Displayed Yes
U013187 Lost Communication With Power Steering Control Module Missing Message

When the following continues for 1 second or more:

-

The voltage of the IG1 terminal is 10 V or more.


-

Communication with the power steering ECU (rack and pinion power steering gear assembly) cannot be performed.



·

CAN communication system

·

4WD ECU assembly

·

Power steering ECU (Rack and pinion power steering gear assembly)


Displayed Yes

PROCEDURE

1.CHECK FOR DTC
a.

Check for DTCs.

Chassis > Four Wheel Drive > Trouble Codes
50001 448

b.

Record the output DTCs (dynamic torque vectoring AWD system).

HINT:

When DTCs indicating a CAN communication system malfunction are output, repair the CAN communication system before repairing each corresponding sensor.



Result:
Proceed to
NEXT



NEXT

GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)