Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY (for 2GR-FKS)
RM37A0E _52 Drivetrain _086862 DRIVE SHAFT / PROPELLER SHAFT _0421215 REAR DRIVE SHAFT ASSEMBLY(for 2GR-FKS) G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY(for 2GR-FKS)  INSPECTION  


PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C211744

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C157783N46
1.573,1.688 1.802,1.865 0.229,0.177 10 false A

Check whether each drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


Dimension (A):
for Dynamic Torque Vectoring AWD for LH Side 643.6 mm (2.11 ft.)
for RH Side 628.6 mm (2.06 ft.)
for Dynamic Torque Control AWD for LH Side 683.25 mm (2.24 ft.)
for RH Side 703.25 mm (2.31 ft.)