82142A
1.INSTALL NO. 2 INSTRUMENT PANEL WIRE
Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Be sure to only connect the connectors to each corresponding color.
Refer to How to Connect or Disconnect Airbag Connector.
Connect the No. 2 instrument panel wire to the wire harness clamp.
73960A
2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Engage the 3 hooks.
Push in the instrument panel passenger airbag assembly to engage the 3 hooks.
Install the instrument panel passenger airbag assembly with the 2 screws.
3.INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY
82142A
4.CONNECT NO. 2 INSTRUMENT PANEL WIRE
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Connect the No. 2 instrument panel wire.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector.
86741A
5.INSTALL TELEMATICS TRANSCEIVER (w/ Telematics Transceiver)