Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 12.3 Inch Display) › from 2020.11
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0444619 NAVIGATION SYSTEM(for 12.3 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 12.3 Inch Display)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the No. 2 skid control ECU (brake actuator assembly) to the radio receiver assembly.

WIRING DIAGRAM

E448897E01
2.302,1.479 2.906,1.719 0.604,0.24 10 false A57 2.302,1.646 4.219,2.135 1.917,0.49 10 false No. 2 Skid Control ECU (Brake Actuator Assembly) 3.688,0.99 4.292,1.229 0.604,0.24 10 false 24 4.906,1.99 5.51,2.229 0.604,0.24 10 false H5 4.906,2.167 6.677,2.427 1.771,0.26 10 false Radio Receiver Assembly 5.417,1.083 6.021,1.323 0.604,0.24 10 false PKB 5.146,0.99 5.75,1.229 0.604,0.24 10 false 20 3.177,1.104 3.781,1.344 0.604,0.24 10 false EPBW

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) - RADIO RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (NO. 2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) - RADIO RECEIVER ASSEMBLY)
a.

Disconnect the H5 radio receiver assembly connector.


b.

Disconnect the A57 No. 2 skid control ECU (brake actuator assembly) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H5-20 (PKB) - A57-24 (EPBW) Always Below 1 Ω
H5-20 (PKB) or A57-24 (EPBW) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR