Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 12.3 Inch Display) › from 2020.11
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0444619 NAVIGATION SYSTEM(for 12.3 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 12.3 Inch Display)  Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU  


DESCRIPTION

This circuit includes the navigation ECU and radio receiver assembly.

WIRING DIAGRAM

E367997E68
1.292,0.896 1.896,1.167 0.604,0.271 10 false REV2 1.76,0.781 2.365,1.052 0.604,0.271 10 false 19 5.313,0.781 5.917,1.052 0.604,0.271 10 false 28 0.771,1.802 1.375,2.073 0.604,0.271 10 false H18 0.771,1.958 1.833,2.25 1.063,0.292 10 false Navigation ECU 5.177,1.813 5.781,2.083 0.604,0.271 10 false H6 5.177,1.969 6.938,2.24 1.76,0.271 10 false Radio Receiver Assembly 5.573,0.885 6.177,1.156 0.604,0.271 10 false REV2

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the H6 radio receiver assembly connector.


b.

Disconnect the H18 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H6-28 (REV2) - H18-19 (REV2) Always Below 1 Ω
H6-28 (REV2) or H18-19 (REV2) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR