Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM (for 12.3 Inch Display) › from 2020.11
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0444619 NAVIGATION SYSTEM(for 12.3 Inch Display) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for 12.3 Inch Display)  Radio Receiver Power Source Circuit  


DESCRIPTION

This is the power source circuit to operate the radio receiver assembly.

WIRING DIAGRAM

E393688E91
0.406,0.76 2.24,0.958 1.833,0.198 10 false from Auxiliary Battery 0.75,1.563 2.896,1.76 2.146,0.198 10 false from ACC Relay 0.448,2.375 3.51,2.573 3.063,0.198 10 false from IG1-NO. 1 Relay 3.25,0.938 4.198,1.198 0.948,0.26 10 false RADIO NO. 2 3.354,1.75 4.427,1.948 1.073,0.198 10 false ECU-ACC 3.188,2.552 5.177,2.75 1.99,0.198 10 false ECU-IG1 NO. 4 5.469,0.792 5.781,0.99 0.313,0.198 10 false H4 5.469,2.375 5.781,2.573 0.313,0.198 10 false H5 5.51,0.573 5.667,0.771 0.156,0.198 10 false 4 5.469,1.396 5.781,1.594 0.313,0.198 10 false 15 5.469,2.167 5.781,2.365 0.313,0.198 10 false 19 5.5,2.969 5.656,3.167 0.156,0.198 10 false 1 5.802,0.781 6.26,0.979 0.458,0.198 10 false +B1 5.792,1.594 6.406,1.792 0.615,0.198 10 false ACC1 5.802,2.385 6.115,2.583 0.313,0.198 10 false IG 5.792,3.177 6.406,3.375 0.615,0.198 10 false GND1 5.365,3.625 7.042,4.292 1.677,0.667 10 false Radio Receiver Assembly 5.469,1.583 5.781,1.781 0.313,0.198 10 false H4 5.469,3.156 5.781,3.354 0.313,0.198 10 false H4

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY POWER SOURCE)
a.

Disconnect the H4 and H5 radio receiver assembly connectors.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H4-1 (GND1) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
H4-4 (+B1) - H4-1 (GND1) Ignition switch off 11 to 14 V
H4-15 (ACC1) - H4-1 (GND1) Ignition switch ACC 11 to 14 V
H5-19 (IG) - H4-1 (GND1) Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR