Home › Power Source / Network › 2GR-FKS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2020.11
RM37A0E _57 Power Source / Network _086881 2GR-FKS BATTERY / CHARGING _0445313 BATTERY CURRENT SENSOR A

2GR-FKS BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Engage the 4 claws to install the battery state sensor assembly to the battery current sensor holder.


b.

Engage the wire harness clamp.


c.

Connect the battery state sensor assembly connector.


d.

Install the battery state sensor assembly to the battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


e.

Connect the earth wire to the battery state sensor assembly.


f.

Connect the engine wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION