Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM (for HV Model) › from 2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0418319 DYNAMIC RADAR CRUISE CONTROL SYSTEM(for HV Model) C

CRUISE CONTROL  DYNAMIC RADAR CRUISE CONTROL SYSTEM(for HV Model)  U031851  Software Incompatibility with Brake System Control Module Not Programmed  


DESCRIPTION

If the forward recognition camera cannot verify the vehicle information sent from the No. 2 skid control ECU (brake actuator assembly), the forward recognition camera stores DTC U031851.

DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
U031851 Software Incompatibility with Brake System Control Module Not Programmed The vehicle information sent from the No. 2 skid control ECU (brake actuator assembly) cannot be verified by the forward recognition camera. Forward recognition camera Radar Cruise2

CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the forward recognition camera, replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle and a DTC may be stored.

·

When the forward recognition camera is replaced with a new one or the windshield glass is replaced or removed/installed, make sure to read Before Starting Adjustment, then perform optical axis alignment for the forward recognition camera and clear the vehicle control history for each system.

HINT:

Forward recognition camera axis alignment can be performed by using either One Time Recognition, Sequential Recognition or Driving Adjustment.

One Time Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(ONE TIME RECOGNITION)

Sequential Recognition: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>TARGET ADJUSTMENT(SEQUENTIAL RECOGNITION)

Driving Adjustment: Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>DRIVING ADJUSTMENT




PROCEDURE

1.REPLACE FORWARD RECOGNITION CAMERA
a.

Replace the forward recognition camera with a new one.

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>REMOVAL


Result:
Proceed to
NEXT



NEXT

2.CLEAR DTC
2.CLEAR DTC
a.

Clear the DTCs.

Powertrain > Radar Cruise2 > Clear DTCs
50002 426

Result:
Proceed to
NEXT



NEXT

END