CHECK VEHICLE APPROACHING SPEAKER CONTROLLER
Disconnect the A50 vehicle approaching speaker controller connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| A50-1 (IG) - Body ground | IG power supply | Ignition switch ON | 11 to 14 V |
| Ignition switch off | Below 1 V | ||
| A50-6 (GND) - Body ground | Ground | Always | Below 1 Ω |
Connect the A50 vehicle approaching speaker controller connector.
Measure the check for pulses according to the value(s) in the table below.
| Terminal No. (Symbol) | Terminal Description | Condition | Specified Condition |
|---|---|---|---|
| A50-7 (SP+) - A50-8 (SP-) | Vehicle approaching speaker assembly output | Vehicle approaching speaker assembly operating | A waveform synchronized with the sound is output.
(See Waveform) |
| A50-3 (CANH) - A50-6 (GND) | CAN communication line | Ignition switch ON | Pulse generation |
| A50-4 (CANL) - A50-6 (GND) | CAN communication line | Ignition switch ON | Pulse generation |
Waveform
| Item | Condition |
|---|---|
| Tester Connection | A50-7 (SP+) - A50-8 (SP-) |
| Tool Setting | 1 V/DIV., 500 ms./DIV. |
| Condition | Vehicle approaching speaker assembly operating |