Home › Vehicle Exterior › VEHICLE PROXIMITY NOTIFICATION SYSTEM › VEHICLE PROXIMITY NOTIFICATION SYSTEM › from 2020.11
RM37A0E _59 Vehicle Exterior _094410 VEHICLE PROXIMITY NOTIFICATION SYSTEM _0448770 VEHICLE PROXIMITY NOTIFICATION SYSTEM C

VEHICLE PROXIMITY NOTIFICATION SYSTEM  VEHICLE PROXIMITY NOTIFICATION SYSTEM  B1350  Speaker Circuit  


DESCRIPTION

The vehicle approaching speaker assembly circuit consists of the vehicle approaching speaker controller and vehicle approaching speaker assembly.

This DTC is stored when a malfunction is detected in the vehicle approaching speaker assembly circuit or vehicle approaching speaker controller.

DTC No. Detection Item DTC Detection Condition Trouble Area
B1350 Speaker Circuit
Detection condition:
1.

The ignition switch is ON.

2.

IG power source voltage is 10 V or more.


Malfunction status:
1.

When ECU output sound signal is being monitored with warning sound not being output, a speaker circuit open, short or short to ground is detected.

2.

When vehicle proximity warning sound output conditions are met, an internal malfunction is continuously detected in the vehicle approaching speaker controller.


Malfunction duration:
1.

6 seconds or more

2.

3 seconds or more


·

Vehicle approaching speaker controller

·

Vehicle approaching speaker assembly

·

Harness or connector



WIRING DIAGRAM

E402276E32
1.094,1.917 1.552,2.115 0.458,0.198 10 false A12 1.083,2.073 2.375,2.583 1.292,0.51 10 false Vehicle Approaching Speaker Assembly 4.75,1.938 5.208,2.135 0.458,0.198 10 false A50 4.76,2.094 6.042,2.563 1.281,0.469 10 false Vehicle Approaching Speaker Controller 2.104,0.969 2.563,1.167 0.458,0.198 10 false 2 2.104,1.375 2.563,1.573 0.458,0.198 10 false 1 4.75,0.99 5.208,1.188 0.458,0.198 10 false 7 4.75,1.375 5.208,1.573 0.458,0.198 10 false 8 4.938,1.073 5.396,1.271 0.458,0.198 10 false SP+ 4.938,1.49 5.396,1.688 0.458,0.198 10 false SP-

PROCEDURE

1.INSPECT VEHICLE APPROACHING SPEAKER ASSEMBLY

OK

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)

NG

2.CHECK HARNESS AND CONNECTOR (VEHICLE APPROACHING SPEAKER ASSEMBLY - VEHICLE APPROACHING SPEAKER CONTROLLER)
a.

Disconnect the A50 vehicle approaching speaker controller connector.


b.

Disconnect the A12 vehicle approaching speaker assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A12-2 - A50-7 (SP+) Always Below 1 Ω
A12-1 - A50-8 (SP-) Always Below 1 Ω
A12-2 or A50-7 (SP+) - Body ground Always 10 kΩ or higher
A12-1 or A50-8 (SP-) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR