If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers.
Thus sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly or speakers.
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Enter the "System Check Mode" screen. Refer to Check Speaker in Operation Check.
Perform the operation check above and determine the speaker that is not operating.
If sound cannot be heard from any speaker, inspect all of them.
| Not Operating Speaker | Proceed to |
|---|---|
| Front No. 1 speaker assembly or front No. 3 speaker assembly | A |
| Front No. 2 speaker assembly | B |
| Rear speaker assembly | C |
| Rear No. 2 speaker assembly | D |
| Rear No. 3 speaker assembly | E |
A
B
C
D
E
Disconnect the M37 stereo component amplifier assembly connector.
Disconnect the J1 and J17 front No. 1 speaker assembly connectors.
Disconnect the H13 and H14 front No. 3 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M37-15 (FR+) - H13-4 (+) | Always | Below 1 Ω |
| M37-30 (FR-) - H13-2 (-) | Always | Below 1 Ω |
| M37-11 (FL+) - H14-4 (+) | Always | Below 1 Ω |
| M37-26 (FL-) - H14-2 (-) | Always | Below 1 Ω |
| J1-2 - H13-3 (+) | Always | Below 1 Ω |
| J1-1 - H13-1 (-) | Always | Below 1 Ω |
| J17-2 - H14-3 (+) | Always | Below 1 Ω |
| J17-1 - H14-1 (-) | Always | Below 1 Ω |
| M37-15 (FR+) or H13-4 (+) - Body ground | Always | 10 kΩ or higher |
| M37-30 (FR-) or H13-2 (-) - Body ground | Always | 10 kΩ or higher |
| M37-11 (FL+) or H14-4 (+) - Body ground | Always | 10 kΩ or higher |
| M37-26 (FL-) or H14-2 (-) - Body ground | Always | 10 kΩ or higher |
| J1-2 or H13-3 (+) - Body ground | Always | 10 kΩ or higher |
| J1-1 or H13-1 (-) - Body ground | Always | 10 kΩ or higher |
| J17-2 or H14-3 (+) - Body ground | Always | 10 kΩ or higher |
| J17-1 or H14-1 (-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>REMOVAL
Inspect the front No. 1 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>FRONT DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 3 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>REMOVAL
Inspect the front No. 3 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>PILLAR SPEAKER>INSPECTION
Malfunction disappears.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M37 stereo component amplifier assembly connector.
Disconnect the H72 and H74 front No. 2 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M37-14 (TWR+) - H72-2 (TWR+) | Always | Below 1 Ω |
| M37-29 (TWR-) - H72-1 (TWR-) | Always | Below 1 Ω |
| M37-13 (TWL+) - H74-2 (TWL+) | Always | Below 1 Ω |
| M37-28 (TWL-) - H74-1 (TWL-) | Always | Below 1 Ω |
| M37-14 (TWR+) or H72-2 (TWR+) - Body ground | Always | 10 kΩ or higher |
| M37-29 (TWR-) or H72-1 (TWR-) - Body ground | Always | 10 kΩ or higher |
| M37-13 (TWL+) or H74-2 (TWL+) - Body ground | Always | 10 kΩ or higher |
| M37-28 (TWL-) or H74-1 (TWL-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>REMOVAL
Inspect the front No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>INSTRUMENT PANEL SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M37 stereo component amplifier assembly connector.
Disconnect the K1 and K6 rear speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M37-12 (RR+) - K1-2 | Always | Below 1 Ω |
| M37-27 (RR-) - K1-1 | Always | Below 1 Ω |
| M37-4 (RL+) - K6-2 | Always | Below 1 Ω |
| M37-19 (RL-) - K6-1 | Always | Below 1 Ω |
| M37-12 (RR+) or K1-2 - Body ground | Always | 10 kΩ or higher |
| M37-27 (RR-) or K1-1 - Body ground | Always | 10 kΩ or higher |
| M37-4 (RL+) or K6-2 - Body ground | Always | 10 kΩ or higher |
| M37-19 (RL-) or K6-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>REMOVAL
Inspect the rear speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>REAR DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M37 stereo component amplifier assembly connector.
Disconnect the M36 rear No. 2 speaker assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M37-8 (WF1+) - M36-4 (WF1+) | Always | Below 1 Ω |
| M37-23 (WF1-) - M36-3 (WF1-) | Always | Below 1 Ω |
| M37-7 (WF2+) - M36-2 (WF2+) | Always | Below 1 Ω |
| M37-22 (WF2-) - M36-1 (WF2-) | Always | Below 1 Ω |
| M37-8 (WF1+) or M36-4 (WF1+) - Body ground | Always | 10 kΩ or higher |
| M37-23 (WF1-) or M36-3 (WF1-) - Body ground | Always | 10 kΩ or higher |
| M37-7 (WF2+) or M36-2 (WF2+) - Body ground | Always | 10 kΩ or higher |
| M37-22 (WF2-) or M36-1 (WF2-) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>REMOVAL
Inspect the rear No. 2 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>LUGGAGE SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M37 stereo component amplifier assembly connector.
Disconnect the W22 and W23 rear No. 3 speaker assembly connectors.
Measure the resistance according to the value (s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M37-9 (SR+) - W22-2 | Always | Below 1 Ω |
| M37-24 (SR-) - W22-1 | Always | Below 1 Ω |
| M37-5 (SL+) - W23-2 | Always | Below 1 Ω |
| M37-20 (SL-) - W23-1 | Always | Below 1 Ω |
| M37-9 (SR+) or W22-2 - Body ground | Always | 10 kΩ or higher |
| M37-24 (SR-) or W22-1 - Body ground | Always | 10 kΩ or higher |
| M37-5 (SL+) or W23-2 - Body ground | Always | 10 kΩ or higher |
| M37-20 (SL-) or W23-1 - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the rear No. 3 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>BACK DOOR SPEAKER>REMOVAL
Inspect the rear No. 3 speaker assembly.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>BACK DOOR SPEAKER>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG