Home › Engine / Hybrid System › CRUISE CONTROL › FRONT RADAR SENSOR SYSTEM › from 2020.11
RM37A0E _51 Engine / Hybrid System _086858 CRUISE CONTROL _0418324 FRONT RADAR SENSOR SYSTEM U

CRUISE CONTROL  FRONT RADAR SENSOR SYSTEM  TERMINALS OF ECU  


CHECK MILLIMETER WAVE RADAR SENSOR ASSEMBLY


A402620E13
3.365,0.063 3.792,0.302 0.427,0.24 3.479,0.104 3.938,0.302 0.458,0.198 10 false B6

NOTICE:
·

DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the GTS once the inspection has been completed.

·

Do not apply excessive force to the forward recognition camera connector.



a.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Terminal Description Condition Specified Condition
B6-1 (SGND) - Body ground Ground Always Below 1 Ω
B6-8 (IGB) - B6-1 (SGND) Power source Ignition switch ON 10.5 to 16 V*1
11 to 14 V*2
Ignition switch off Below 1 V

*1: w/ Stop and Start System

*2: w/o Stop and Start System



b.

Check for pulses according to the value(s) in the table below.

HINT:

If the waveform is not similar to that shown in the illustration, a malfunction of a CAN bus line, terminating resistor, or the millimeter wave radar sensor assembly is suspected.


Terminal No. (Symbol) Terminal Description Condition Specified Condition
B6-2 (CA2L) - B6-1 (SGND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 2)
B6-3 (CA2H) - B6-1 (SGND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 1)
B6-5 (CA1P) - B6-1 (SGND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 1)
B6-6 (CA1N) - B6-1 (SGND) CAN communication signal Ignition switch ON Pulse generation
(See waveform 2)

i.
A438764N02
3.031,1.406 3.344,1.698 0.313,0.292 10 false GND

Waveform 1

Item Content
Tester Connection
·

Between B6-3 (CA2H) and B6-1 (SGND)

·

Between B6-5 (CA1P) and B6-1 (SGND)


Tool Setting 1 V/DIV., 10 μs./DIV.
Condition Ignition switch ON

HINT:

The waveform varies depending on the CAN communication signal.



ii.
A438765N02
3.031,1.375 3.406,1.625 0.375,0.25 10 false GND

Waveform 2

Item Content
Tester Connection
·

Between B6-2 (CA2L) and B6-1 (SGND)

·

Between B6-6 (CA1N) and B6-1 (SGND)


Tool Setting 1 V/DIV., 10 μs./DIV.
Condition Ignition switch ON

HINT:

The waveform varies depending on the CAN communication signal.