Home › Engine / Hybrid System › A25A-FXS, A25B-FXS (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2020.11
RM37A0E _51 Engine / Hybrid System _086908 A25A-FXS EMISSION CONTROL _0449632 DIFFERENTIAL PRESSURE SENSOR A

A25A-FXS EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 25715 1.INSTALL EMISSION CONTROL VALVE BRACKET

HINT:

Perform this procedure only when replacement of the emission control valve bracket is necessary.


a.

Install the emission control valve bracket to the fuel pump flange with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide 89481B 2.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Install the differential pressure sensor to the emission control valve bracket with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Connect the No. 1 vacuum transmitting pipe sub-assembly to the differential pressure sensor and slide the clip to secure it.


c.

Connect the differential pressure sensor connector.


Hide 12601B 3.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY