Home › Drivetrain › UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE) › OIL PUMP › from 2020.11
RM37A0E _52 Drivetrain _094409 UA80E AUTOMATIC TRANSMISSION / TRANSAXLE _0449691 OIL PUMP A

UA80E AUTOMATIC TRANSMISSION / TRANSAXLE  OIL PUMP  DISASSEMBLY  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during oil pump with solenoid assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Replacement of oil pump with solenoid assembly Check the oil pump with solenoid assembly Stop and Start System (Click here)

PROCEDURE

Hide 35617 1.REMOVE CLUTCH DRUM OIL SEAL RING

a.
C427049

Remove the 4 clutch drum oil seal rings from the stator shaft assembly.


Hide 35330F 2.REMOVE OIL STRAINER ASSEMBLY

a.
C427050

Using a T30 "TORX" socket wrench, remove the 2 bolts and oil strainer assembly from the front oil pump cover sub-assembly.


Hide 3.REMOVE TRANSMISSION WIRE (OIL PUMP WITH SOLENOID ASSEMBLY)

a.
C427024

Disconnect the connector to remove the transmission wire (oil pump with solenoid assembly).


Hide 4.REMOVE OIL PUMP WITH SOLENOID ASSEMBLY

a.
C384596

Remove the bolt and oil pump with solenoid assembly from the front oil pump cover sub-assembly.


Hide 35370 5.REMOVE STATOR SHAFT ASSEMBLY

a.
C362580

Remove the 5 bolts and stator shaft assembly from the front oil pump body.


Hide 35321 6.REMOVE FRONT OIL PUMP DRIVE GEAR

a.
C362581

Remove the front oil pump drive gear from the front oil pump body.


Hide 35322 7.REMOVE FRONT OIL PUMP DRIVEN GEAR

a.
C362582

Remove the front oil pump driven gear from the front oil pump body.


Hide 35311 8.REMOVE FRONT OIL PUMP BODY

a.
C362583

Remove the front oil pump body from the front oil pump cover sub-assembly.


Hide 9.REMOVE RING PIN

a.
C362584

Remove the 2 ring pins from the front oil pump cover sub-assembly.