Home › Engine / Hybrid System › STOP AND START › STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY › from 2020.11
RM37A0E _51 Engine / Hybrid System _094408 STOP AND START _0452245 STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY G

STOP AND START  STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY  INSPECTION  


PROCEDURE

Hide 84470A 1.INSPECT ECORUN CANCEL SWITCH ASSEMBLY

a.
C425596C06
1.469,0.167 1.927,0.417 0.458,0.25 1.135,1.719 1.396,1.354 true 2.344,1.719 2.01,1.354 true 0.146,0.146 0.458,0.302 0.313,0.156 10 false *a 1,1.75 1.344,1.948 0.344,0.198 10 false ECU 2.323,1.729 2.479,1.927 0.156,0.198 10 false E 1.615,0.208 2.229,0.406 0.615,0.198 10 false P7
*a Component without harness connected
(Ecorun Cancel Switch Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Switch Condition Specified Condition
P7-5 (ECU) - P7-2 (E) Ecorun cancel switch assembly being pushed and held Below 1 Ω
Ecorun cancel switch assembly not pushed 10 kΩ or higher


If the result is not as specified, replace the ecorun cancel switch assembly.