Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
63436B
1.INSTALL NO. 1 ROOF CARRIER SEAL
When installing new No. 1 roof carrier seals, heat the front roof rack leg using a heat light.
| Item | Temperature |
|---|---|
| Front Roof Rack Leg | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the front roof rack leg excessively.
Clean the front roof rack leg.
Using a heat light, heat the front roof rack leg surface.
Remove any remaining double-sided tape from the front roof rack leg.
Wipe off any tape adhesive residue with cleaner.
Install 2 new No. 1 roof carrier seals.
Using a heat light, heat the front roof rack leg surface.
Remove the release paper from each No. 1 roof carrier seal.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the 2 No. 1 roof carrier seals.
Press the No. 1 roof carrier seals to install them.
63437D
2.INSTALL NO. 2 ROOF CARRIER SEAL
When installing new No. 2 roof carrier seals, heat the rear roof rack leg using a heat light.
| Item | Temperature |
|---|---|
| Rear Roof Rack Leg | 20 to 30°C (68 to 86°F) |
| *a | Heated Part |
| *b | Heat Light |
Do not touch the heat light and heated parts, touching the heat light may result in burns.
Touching heated parts for a long time may result in burns.
Do not heat the rear roof rack leg excessively.
Clean the rear roof rack leg.
Using a heat light, heat the rear roof rack leg surface.
Remove any remaining double-sided tape from the rear roof rack leg.
Wipe off any tape adhesive residue with cleaner.
Install 2 new No. 2 roof carrier seals.
Using a heat light, heat the rear roof rack leg surface.
Remove the release paper from each No. 2 roof carrier seal.
After removing the release paper, keep the exposed adhesive free from foreign matter.
Install the 2 No. 2 roof carrier seals.
Press the No. 2 roof carrier seals to install them.
75506B
3.INSTALL FRONT ROOF SIDE GARNISH SUB-ASSEMBLY
Install 2 new clips to the front roof side garnish sub-assembly.
| *1 | Rear Roof Rack Leg |
Engage the clip.
Install the rear roof rack leg with the bolt.
| *1 | Front Roof Rack Leg |
Engage the clip.
Install the front roof side garnish sub-assembly to the front roof rack leg with the bolt.
75632A
4.INSTALL NO. 1 ROOF SIDE GARNISH LID
|
Install in this Direction |
Engage the 4 claws to install the No. 1 roof side garnish lid as shown in the illustration.
75634
5.INSTALL NO. 2 ROOF SIDE GARNISH LID
|
Install in this Direction |
Engage the 4 claws to install the No. 2 roof side garnish lid as shown in the illustration.