Home › Power Source / Network › 2GR-FKS (BATTERY / CHARGING) › CHARGING SYSTEM (w/ Stop And Start System) › from 2020.11
RM37A0E _57 Power Source / Network _086881 2GR-FKS BATTERY / CHARGING _0452458 CHARGING SYSTEM(w/ Stop And Start System) C

2GR-FKS BATTERY / CHARGING  CHARGING SYSTEM(w/ Stop And Start System)  P160200  Deterioration of Battery Low Capacity  


DESCRIPTION

The ECM determines the battery SOC (state of charge) according to the voltage of the BATT terminal while the engine is running (not cranking).

DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Memory Note
P160200 Deterioration of Battery Low Capacity Battery capacity is low for 10 seconds or more when the engine is running (not cranking).
(1 trip detection logic)
·

Battery

·

Wire harness or connector


Charge warning is not displayed DTC stored SAE Code: P1602

WIRING DIAGRAM

A457099E01
5.208,2.354 5.823,2.552 0.615,0.198 10 false C54 5.198,1.135 5.656,1.333 0.458,0.198 10 false A28 5.583,1.125 6.198,1.323 0.615,0.198 10 false BATT 5.583,2.365 5.896,2.563 0.313,0.198 10 false E1 3.844,1.302 5.073,1.5 1.229,0.198 10 false EFI NO.1 1.177,2.281 2.25,2.479 1.073,0.198 10 false Battery 1.844,1.292 2.458,1.49 0.615,0.198 10 false FL MAIN 5.927,3.25 6.385,3.448 0.458,0.198 10 false ECM 5.281,0.906 5.438,1.104 0.156,0.198 10 false 1 5.271,2.135 5.583,2.333 0.313,0.198 10 false 53

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


HINT:

If any DTCs other than P160200 are output, troubleshoot those DTCs first.


PROCEDURE

1.CHECK CHARGING SYSTEM

OK

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)

NG

REPAIR OR REPLACE CHARGING SYSTEM

2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT)
a.

Disconnect the A28 ECM connector.


b.
A371640C34
1.583,0.76 1.958,0.979 0.375,0.219 0.927,2.646 1.229,1.521 true 0.083,0.042 0.396,0.24 0.313,0.198 10 false *a 0.76,2.677 1.375,2.875 0.615,0.198 10 false BATT 1.646,0.792 2.26,0.99 0.615,0.198 10 false A28
*a Front view of wire harness connector
(to ECM)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
A28-1 (BATT) - Body ground Always 11 to 14 V



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - ECM)