Home › Vehicle Interior › MIRROR (INT) › DIGITAL INNER MIRROR › from 2020.11
RM37A0E _58 Vehicle Interior _086890 MIRROR (INT) _0452769 DIGITAL INNER MIRROR G

MIRROR (INT)  DIGITAL INNER MIRROR  INSPECTION  


PROCEDURE

Hide 87810 1.INSPECT INNER REAR VIEW MIRROR ASSEMBLY

a.

Inspect the operation of the electrochromic inner rear view mirror assembly.

B601811C01
4.917,1.063 4.75,0.729 true 4.625,1.313 4.458,0.979 false 3.979,2.552 4.146,2.385 false 4.354,2.531 4.313,2.365 false 5.958,2.552 6.125,2.385 false 4.49,2.365 4.542,2.521 4.542,2.521 4.406,2.365 false 6.458,2.365 6.521,2.521 6.521,2.521 6.375,2.365 false 6.333,2.531 6.271,2.365 false 4.583,1.313 4.896,1.469 0.313,0.156 10 false *a 4.875,1.063 5.188,1.219 0.313,0.156 10 false *b 3.5,1.833 3.813,1.99 0.313,0.156 10 false *c 5.5,1.833 5.813,1.99 0.313,0.156 10 false *d 1.156,0.906 1.469,1.063 0.313,0.156 10 false *e 2.656,0.26 2.948,0.573 0.292,0.313 10 false *i 5.833,2.51 6.146,2.667 0.313,0.156 10 false *f 4.281,2.521 4.594,2.719 0.313,0.198 10 false *g 4.51,2.531 4.823,2.729 0.313,0.198 10 false *h 3.865,2.51 4.177,2.708 0.313,0.198 10 false *f 6.271,2.51 6.583,2.708 0.313,0.198 10 false *g 6.49,2.521 6.802,2.719 0.313,0.198 10 false *h
*a Black Colored Tape *b Ambient Light Sensor
*c Bright *d Dark
*e Auxiliary Battery *f Mode Selection Lever
*g Menu/Select Switch *h Cursor Operation Switch
*i Component without harness connected
(Inner Rear View Mirror Assembly)
- -


i.

Connect a positive (+) lead from the auxiliary battery to terminal 1 and terminal 6 and a negative (-) lead to terminal 2.


ii.

Confirm that the mode selection lever is set to the optical mirror mode side.

HINT:

If the mode selection lever is set to the digital mirror mode side, move it to the optical mirror mode side.



iii.

Attach black colored tape to the ambient light sensor to prevent it from sensing.


iv.

Press the Menu/Select switch on the selection switch and turn on automatic anti-glare mode using the cursor operation switches.


v.

Light up the mirror with an electric light, and check that the mirror surface changes from bright to dark.

OK:

Mirror surface changes from bright to dark.


If the result is not as specified, replace the inner rear view mirror assembly.