This circuit sends a charging suspension signal from the certification ECU (smart key ECU assembly) to the mobile wireless charger cradle. Based on this signal, the mobile wireless charger cradle suspends or resumes wireless charging.
The wireless charging system uses the same radio wave frequency that is used to perform verification of the electrical key transmitter sub-assembly. Therefore, when the electrical key transmitter sub-assembly verification is being performed, the certification ECU (smart key ECU assembly) sends a charging suspension signal to the wireless charging system to suspend charging.
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
| *a | Component with harness connected
(Mobile Wireless Charger Cradle) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
*1: When the ignition switch is turned from off to ACC, the mobile wireless charger cradle monitors the charging suspension signal for 5 seconds. If the charging suspension signal is not 4 V or more for 0.8 seconds or more during monitoring, the mobile wireless charger cradle determines that there is an open in the charging suspension signal line, blinks (pattern 1) the indicator light (amber), and prohibits operation until the ignition switch is turned from off to ACC again. *2: For details about conditions when the certification ECU (smart key ECU assembly) sends the charging suspension signal, refer to System Description. |
||
| T9-7 (DIS) - Body ground | For 5 seconds after turning ignition switch from off to ACC*1 | 4.5 to 6.0 V |
| Device being charged | Below 1 V | |
| Charging suspended due to smart key system status*2 | 4.5 to 6.0 V | |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the M5 certification ECU (smart key ECU assembly) connector.
Disconnect the T9 mobile wireless charger cradle connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M5-7 (WCSW) - T9-7 (DIS) | Always | Below 1 Ω |
| M5-7 (WCSW) or T9-7 (DIS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG