Home › Vehicle Interior › POWER OUTLETS (INT) › WIRELESS CHARGING SYSTEM › from 2020.11
RM37A0E _58 Vehicle Interior _086897 POWER OUTLETS (INT) _0453072 WIRELESS CHARGING SYSTEM J

POWER OUTLETS (INT)  WIRELESS CHARGING SYSTEM  Wireless Charger Illumination Circuit  


DESCRIPTION

When the taillight is on, this circuit sends an illumination signal to the mobile wireless charger cradle.

WIRING DIAGRAM

E215957E30
1.177,0.938 2.198,1.115 1.021,0.177 10 false from TAIL Relay 3.344,1.073 3.823,1.25 0.479,0.177 10 false PANEL 4.813,0.927 5.229,1.104 0.417,0.177 10 false TAIL 4.542,0.844 4.771,1.021 0.229,0.177 10 false 10 4.552,1.448 6.625,1.75 2.073,0.302 10 false Mobile Wireless Charger Cradle 4.552,1.292 4.927,1.469 0.375,0.177 10 false T9

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ILLUMINATION SIGNAL)
a.

Disconnect the T9 mobile wireless charger cradle connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
T9-10 (TAIL) - Body ground Taillight off Below 1 V
Ignition switch off, taillight on 11 to 14 V



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR