If cool air is not discharged (air is discharged), the following malfunctions are possible.
| Malfunction Status | Factor |
|---|---|
| Cool air is not discharged (air is discharged) | ·
Compressor with motor assembly malfunction ·
Refrigerant pressure malfunction ·
Lack of refrigerant gas ·
Dirty cooler condenser ·
Cooling fan system malfunction ·
Air mix damper and link operation (jamming) ·
Evaporator temperature sensor (determined as cold, but conflicts with actual temperature) ·
Warm air flow |
Operate each switch on the air conditioning control assembly and check that the switch indicators operate normally.
All switch indicators operate normally.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for Air conditioning control assembly) | B |
| NG (for No. 2 air conditioning control assembly) | C |
A
B
C
Perform the Active Test according to the display on the GTS.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Targ Pulse(D) | No. 1 air conditioning radiator damper servo sub-assembly (air mix) pulse | Min.: 128
Max.: 383 |
Operates between 165 to 257 pulses |
| Rear Air Mix Servo Targ Pulse | Rear air mix damper servo sub-assembly pulse | Min.: 128
Max.: 383 |
Operates between 213 to 258 pulses |
| Tester Display |
|---|
| Air Mix Servo Targ Pulse(D) |
| Tester Display |
|---|
| Rear Air Mix Servo Targ Pulse |
Damper servo motor is operated.
| Proceed to |
|---|
| OK |
| NG |
OK
NG