Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › TOYOTA MULTI OPERATION TOUCH SYSTEM › from 2020.11
RM37A0E _56 Audio / Visual / Telematics _086878 NAVIGATION / MULTI INFO DISPLAY _0453179 TOYOTA MULTI OPERATION TOUCH SYSTEM J

NAVIGATION / MULTI INFO DISPLAY  TOYOTA MULTI OPERATION TOUCH SYSTEM  Illumination Circuit  


WIRING DIAGRAM

E459766E01
5.563,0.479 5.917,0.667 0.354,0.188 10 false ILL+ 5.354,0.385 5.813,0.74 0.458,0.354 10 false 5 5.552,1.427 5.969,1.635 0.417,0.208 10 false GND 5.479,1.917 5.979,2.156 0.5,0.24 10 false H8 2.396,0.469 3.885,0.823 1.49,0.354 10 false from TAIL Relay 5.469,2.083 6.646,2.563 1.177,0.479 10 false Integration Control Sub-assembly 5.302,1.281 5.583,1.51 0.281,0.229 10 false 20 4.031,0.646 4.75,0.875 0.719,0.229 10 false PANEL

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (INTEGRATION CONTROL SUB-ASSEMBLY POWER SOURCE)
a.

Disconnect the H8 integration control sub-assembly connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H8-5 (ILL+) - Body Ground Ignition switch ON 11 to 14 V



c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H8-20 (GND) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR