1. REGISTER VEHICLE INFORMATION
If the telematics transceiver has been replaced, it is necessary to perform the Register Vehicle Information procedure.
Enter the following menus: Body Electrical / Telematics / Utility / VIN Synchronization
| Tester Display |
|---|
| VIN Synchronization |
According to the display on the GTS, perform VIN Synchronization to register the VIN to the telematics transceiver.
According to the display on the GTS, read the IMEI, ICCID and VIN.
Turn the ignition switch off.
Turn the ignition switch to ON and wait for approximately 20 minutes.
Turn the ignition switch ON and check the illumination status of the manual (SOS) switch indicators.
If the indicators illuminate in the following pattern, activation is complete: red (10 sec.), green (2 sec.), red and green together (1sec), then only green stays illuminated.
If both the indicators (red and green) do not illuminate for 1 second, turn the ignition switch from off to ON and wait 1 minute. After that, turn the ignition switch off then back to ON and check that the indicators illuminate in the above pattern.
Perform test mode.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>OPERATION CHECK