Wear protective gloves. Sharp areas on the seat frame may injure your hands.
71848K
1.REMOVE SEAT ADJUSTER COVER CAP
Remove the 2 seat adjuster cover caps.
72526E
2.REMOVE RECLINING ADJUSTER RELEASE HANDLE LH
| *a | Protective Tape |
|
Remove in this Direction |
Using a screwdriver with its tip wrapped with protective tape, disengage the claw as shown in the illustration and remove the reclining adjuster release handle LH.
72928
3.REMOVE REAR SEAT CUSHION UNDER COVER LH
Disengage the claw, clip and guide to remove the rear seat cushion under cover LH.
71849D
4.REMOVE SEAT ADJUSTER COVER CAP LH
Disengage the 2 claws and 2 guides to remove the seat adjuster cover cap LH.
72058D
5.REMOVE REAR SEAT NO. 1 LOCK CONTROL LEVER SUB-ASSEMBLY LH
Remove the 2 screws.
Disengage the 2 guides.
Disconnect the rear seat reclining control cable to remove the rear seat No. 1 lock control lever sub-assembly LH.
72058E
6.REMOVE REAR SEAT NO. 2 LOCK CONTROL LEVER SUB-ASSEMBLY LH
Remove the 2 screws.
Disengage the 2 guides.
Disconnect the rear No. 1 seat track control cable assembly LH to remove the rear seat No. 2 lock control lever sub-assembly LH.
71826B
7.REMOVE REAR SEAT CUSHION MOULDING LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 5 claws, clip and 14 guides as shown in the illustration to remove the rear seat cushion moulding LH.
8.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER WITH PAD
Disengage the 2 hooks.
Disengage the 3 hooks.
Disengage the clamp.
w/ Seat Heater System:
Disconnect the 2 connectors.
Disengage the 2 clamps.
w/ Occupant Detection Sensor:
Disconnect the connector.
Disengage the clamp.
Disengage the 2 hooks.
Disengage the hook.
Disengage the 6 hooks and remove the separate type rear seat cushion cover with pad.
71076S
9.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER
|
Fastener |
Disengage the 5 fasteners.
Using a screwdriver, disengage the 14 claws as shown in the illustration and remove the separate type rear seat cushion cover from the rear seat cushion pad LH.
| *a | Screwdriver | - | - |
87510Q
10.REMOVE SEAT HEATER ASSEMBLY (w/ Seat Heater System)
87501F
11.REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)
Disconnect the connector.
Disengage the clamp to remove the seat heater control sub-assembly LH.
72616A
12.REMOVE REAR SEATBACK LOCK STRIKER COVER LH
|
Remove in this Direction |
Disengage the claw and 2 guides as shown in the illustration to remove the rear seatback lock striker cover LH.
72054C
13.REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH
Remove the 2 screws.
|
Remove in this Direction |
Disengage the guide as shown in the illustration.
Disconnect the rear seat reclining control cable to remove the reclining remote control lever sub-assembly LH.
72997
14.REMOVE REAR SEATBACK COVER LH
Disengage the 2 claws as shown in the illustration.
|
Remove in this Direction |
Disengage the 6 claws as shown in the illustration to remove the rear seatback cover LH.
71702C
15.REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY LH
|
Fastener |
Open the 2 fasteners as shown in the illustration.
Disengage the hook.
Disengage the 6 clips and 2 claws as shown in the illustration.
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 2 guides as shown in the illustration to remove the rear seatback board sub-assembly LH.
16.REMOVE SEPARATE TYPE REAR SEATBACK COVER WITH PAD
|
Remove in this Direction |
Disengage the 4 claws as shown in the illustration and remove the 2 rear seat headrest supports.
Disengage the hook.
Remove the separate type rear seatback cover with pad.
71078S
17.REMOVE SEPARATE TYPE REAR SEATBACK COVER
Using a screwdriver, disengage the 6 claws as shown in the illustration and remove the separate type rear seatback cover from the separate type rear seatback pad.
| *a | Screwdriver | - | - |
87510S
18.REMOVE SEAT HEATER ASSEMBLY (w/ Seat Heater System)
72598C
19.REMOVE RECLINING REMOTE CONTROL BEZEL LH
Disengage the 2 claws and guide to remove the reclining remote control bezel LH.
71829B
20.REMOVE REAR SEAT CUSHION REAR MOULDING LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 6 claws and 8 guides as shown in the illustration to remove the rear seat cushion rear moulding LH.
71833A
21.REMOVE REAR NO. 1 SEAT RECLINING COVER RH
|
Remove in this Direction |
Disengage the claw and guide as shown in the illustration to remove the rear No. 1 seat reclining cover RH.
71639
22.REMOVE REAR SEAT CUSHION HINGE COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 3 claws as shown in the illustration to remove the rear seat cushion hinge cover LH.
73480A
23.REMOVE REAR SEAT INNER BELT ASSEMBLY LH
71834A
24.REMOVE REAR NO. 1 SEAT RECLINING COVER LH
|
Remove in this Direction |
Disengage the claw and guide as shown in the illustration to remove the rear No. 1 seat reclining cover LH.
72552A
25.REMOVE RECLINING HINGE COVER LH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the 4 claws and clip as shown in the illustration to remove the reclining hinge cover LH.
71692M
26.REMOVE REAR NO. 2 SEAT CUSHION HINGE UPPER COVER LH
|
Remove in this Direction |
Disengage the claw and guide as shown in the illustration to remove the rear No. 2 seat cushion hinge upper cover LH.
71691P
27.REMOVE REAR NO. 2 SEAT CUSHION HINGE UPPER COVER RH
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
Disengage the claw and guide as shown in the illustration to remove the rear No. 2 seat cushion hinge upper cover RH.
82194
28.REMOVE REAR SEAT WIRE LH (w/o Seat Heater System)
Disengage the 7 clamps and remove the rear seat wire LH.
82194
29.REMOVE REAR SEAT WIRE LH (w/ Seat Heater System)
w/o Seat Belt Warning System:
Disengage the 7 clamps and remove the rear seat wire LH.
w/ Seat Belt Warning System:
Disengage the 8 clamps and remove the rear seat wire LH.
30.REMOVE CONNECTOR MALE HOUSING (w/o Seat Heater System)
w/o Seat Belt Warning System:
Disengage the clamp to remove the connector male housing.
72210H
31.REMOVE REAR NO. 1 SEAT TRACK CONTROL CABLE ASSEMBLY LH
Remove the 2 wire harness clamps.
|
Clamp |
|
Wire Harness Clamp |
Disengage the 2 clamps and remove the rear No. 1 seat track control cable assembly LH.
72704A
32.REMOVE REAR SEAT RECLINING CONTROL CABLE
Disengage the 10 clamps and cable clamp.
Disengage the clamp and remove the rear seat reclining control cable.
72308C
33.REMOVE NO. 1 RECLINING CONTROL LINK SUB-ASSEMBLY LH
Remove the 2 nuts and No. 1 reclining control link sub-assembly LH.
72308D
34.REMOVE NO. 2 RECLINING CONTROL LINK SUB-ASSEMBLY LH
Remove the 2 nuts and No. 2 reclining control link sub-assembly LH.
71018
35.REMOVE REAR SEATBACK FRAME SUB-ASSEMBLY LH
|
Remove in this Direction |
Remove the 4 bolts.
Remove the rear seatback frame sub-assembly LH from the No. 1 seat cushion frame sub-assembly LH as shown in the illustration.
72134A
36.REMOVE FRONT INNER SEAT TRACK UPPER RAIL BRACKET LH
Remove the 2 nuts and front inner seat track upper rail bracket LH.
71016A
37.REMOVE REAR SEAT CUSHION FRAME SUB-ASSEMBLY LH
Remove the 4 nuts and rear seat cushion frame sub-assembly LH.