Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2020.11
RM37A0E _55 Steering _086874 POWER ASSIST SYSTEMS _0419667 POWER STEERING SYSTEM U

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  TERMINALS OF ECU  


HINT:
·

The rack and pinion power steering gear assembly uses waterproof connectors. Therefore, voltage or waveforms cannot be checked with the connectors connected to the vehicle.

·

Use the Data List and Active Test on the GTS to check the operation of the rack and pinion power steering gear assembly and check that communication is established.

Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DATA LIST / ACTIVE TEST



CHECK WIRE HARNESS SIDE CONNECTOR


a.

Disconnect the C67 rack and pinion power steering gear assembly connector and measure the voltage or resistance on the wire harness side.

C427074C01
3.365,0.094 3.781,0.323 0.417,0.229 3.458,0.135 3.917,0.333 0.458,0.198 10 false C67 0.094,0.052 0.406,0.25 0.313,0.198 10 false *a
*a Front view of wire harness connector
(to Rack and Pinion Power Steering Gear Assembly)
- -


Terminal No. (Symbol) Terminal Description Condition Specified Condition

*1: w/o Stop and Start System

*2: w/ Stop and Start System

C67-4 (IG) - Body ground IG power source Ignition switch ON 8 to 16 V*1
10.5 to 16 V*2
C67-7 (PGND) - Body ground Power ground Always Below 1 Ω
C67-8 (PIG) - Body ground Power source Always 9 to 16 V
C67-10 (CANH) CAN communication line - -
C67-11 (CANL) CAN communication line - -