This DTC is stored if the parking assist ECU judges that there is an internal malfunction as a result of its self check.
The parking assist ECU stores different types of information during initialization. If the parking assist ECU cannot read the stored information when activated, the parking assist ECU judges that there is an internal malfunction and stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1614 | ECU Malfunction | ·
Power source malfunction ·
Main CPU start malfunction ·
Main CPU reset detected ·
Main CPU regular monitoring malfunction ·
CAN CPU start malfunction ·
System standby malfunction ·
Main EEPROM malfunction ·
Sub EEPROM malfunction ·
Image ASIC RAM malfunction ·
ASIC status malfunction ·
ECU internal display line malfunction |
Parking assist ECU |
When "!" is displayed on the radio and display receiver assembly or multi-display assembly after the cable is disconnected from the negative (-) auxiliary battery terminal, correct the steering angle neutral point.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>INITIALIZATION
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
Use the Data List to check if the parking assist ECU status is functioning properly.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| HV/EV/ENG Data Check | Verification of the HV/ENG data | OK/NG | OK: Data verification normal
NG: Data verification abnormal |
- |
| 2WD/4WD Data Check | Verification of the 2WD/4WD data | OK/NG | OK: Data verification normal
NG: Data verification abnormal |
- |
| Main CPU Forced Termination Detection Record | A history item indicating that the main CPU did not enter standby status within 15 seconds of turning the ignition switch off and a forced end was applied | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Main CPU Abnormal Response Record | A history item indicating that the main CPU became unresponsive in normal status | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Main CPU Abnormal Reset Record | A history item indicating that the main CPU was reset, although the ignition switch was not turned off in normal status | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Image Processing IC Written Protect Record | A history item indicating that the image processing IC memory was write protected | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Image Processing IC Initialized Malfunction Record | A history item indicating that the image processing IC memory was not initialized | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Main EEPROM Access Status | Main EEPROM access status | Normal/Abnormal | Normal: Parking assist ECU is normal
Abnormal: Parking assist ECU is abnormal |
- |
| Sub EEPROM Access Status | Sub-EEPROM access status | Normal/Abnormal | Normal: Parking assist ECU is normal
Abnormal: Parking assist ECU is abnormal |
- |
| System Power Supply Voltage Malfunction Record | A history item indicating an abnormal generated-voltage value from the system power source | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Main CPU Starting Malfunction Record | A history item indicating that the main CPU did not start | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| CAN CPU Boot Malfunction Record | A history item indicating that the CPU controlling the input and output of the information obtained via CAN communication did not start and the information could not be retrieved | No/Yes | No: Parking assist ECU is normal
Yes: Parking assist ECU is abnormal |
- |
| Visual Display Line Status | Displays the status of the video signals displayed on the multi-display | OK/NG | OK: GVIF cable is normal
NG: GVIF cable is abnormal |
- |
| Wheel Speed Sensor (4wheel) | Reception state of the vehicle speed signal from the skid control ECU*1, No. 2 skid control ECU*2 | OK/NG | OK: Speed signal received
NG: Speed signal not received |
- |
| Continuous Bus Off | Continuous bus off status (Global) | Not Detected/Detected | Not detected: Communication condition available
Detected: Communication condition not available |
- |
| Sending CAN Message | Communication condition from parking assist ECU (Global) | OK/NG | OK: Communication condition available
NG: Communication condition not available |
- |
| Camera Changing SW Signal Status | Signal status at the BLSW terminal (switch camera signal) | ON/OFF | ON: Panoramic view monitor main switch on
OFF: Panoramic view monitor main switch off |
- |
| Back Camera Availability Consistency | Status of ECU stored in rear television camera assembly | OK/NG | OK: Normal
NG: Rear television camera assembly or parking assist ECU is abnormal |
- |
| Image Adjustment Status | Status of the image adjustment status | Incomplete/Processing/Complete | Incomplete: Image adjustment incomplete
Processing: Image adjustment in processing Complete: Image adjustment completed |
- |
| Number of DTC | Number of DTCs (past and present) | Min: 0, Max: 255 | Number of DTCs will be displayed | - |
*1: for Gasoline Model
*2: for HV Model
| Tester Display |
|---|
| HV/EV/ENG Data Check |
| 2WD/4WD Data Check |
| Main CPU Forced Termination Detection Record |
| Main CPU Abnormal Response Record |
| Main CPU Abnormal Reset Record |
| Image Processing IC Written Protect Record |
| Image Processing IC Initialized Malfunction Record |
| Main EEPROM Access Status |
| Sub EEPROM Access Status |
| System Power Supply Voltage Malfunction Record |
| Main CPU Starting Malfunction Record |
| CAN CPU Boot Malfunction Record |
| Visual Display Line Status |
| Wheel Speed Sensor (4wheel) |
| Continuous Bus Off |
| Sending CAN Message |
| Camera Changing SW Signal Status |
| Back Camera Availability Consistency |
| Image Adjustment Status |
| Number of DTC |
| Result | Proceed to |
|---|---|
| OK is displayed for all items | A |
| NG is displayed | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
Clear the DTCs.
Check for DTCs.
DTC C1614 is not output.
| Proceed to |
|---|
| OK |
| NG |
If DTC C1614 is output, perform the procedure to allow the parking assist ECU to store the vehicle information again.
If DTC C1614 is still output after performing the procedure to make the parking assist ECU store the vehicle information 3 times, replace the parking assist ECU.
If DTC C1614 is output frequently, replace the parking assist ECU even though the DTC is not output when rechecking for DTCs.
OK
NG