Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR SEAT ENTERTAINMENT SYSTEM › from 2020.11
RM37A0E _56 Audio / Visual / Telematics _086877 AUDIO / VIDEO _0420185 REAR SEAT ENTERTAINMENT SYSTEM J

AUDIO / VIDEO  REAR SEAT ENTERTAINMENT SYSTEM  Television Display Power Source Circuit  


DESCRIPTION

This is the power source circuit to operate the television display assembly.

WIRING DIAGRAM

E436598E05
1.24,0.604 2.813,0.865 1.573,0.26 10 false from Auxiliary Battery*1 1.573,1.979 2.771,2.26 1.198,0.281 10 false from ACC Relay*1 1.177,1.167 3.583,1.448 2.406,0.281 10 false from Engine Stop and Start ECU*2 1.188,2.531 3.594,2.813 2.406,0.281 10 false from Engine Stop and Start ECU*2 3.833,0.781 4.469,1.042 0.635,0.26 10 false RADIO 3.729,2.135 4.927,2.417 1.198,0.281 10 false ECU-ACC 5.802,0.594 6.125,0.833 0.323,0.24 10 false +B 5.802,1.969 6.208,2.208 0.406,0.24 10 false ACC 5.792,3.396 6.198,3.635 0.406,0.24 10 false GND 5.604,0.469 5.802,0.708 0.198,0.24 10 false 1 5.604,1.844 5.802,2.083 0.198,0.24 10 false 2 5.542,3.26 5.844,3.5 0.302,0.24 10 false 17 5.656,3.833 6.063,4.073 0.406,0.24 10 false R16 5.646,4 6.771,4.469 1.125,0.469 10 false Television Display Assembly 0.438,3.719 2.844,4 2.406,0.281 10 false *1: w/o Stop and Start System 0.448,4.063 2.854,4.344 2.406,0.281 10 false *2: w/ Stop and Start System

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (TELEVISION DISPLAY ASSEMBLY POWER SOURCE)
a.

Disconnect the R16 television display assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
R16-17 (GND) - Body ground Always Below 1 Ω



c.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

*1: for Gasoline Model

*2: for HV Model

*3: w/o Stop and Start System

*4: w/ Stop and Start System

R16-1 (+B) - R16-17 (GND) Always*1
Ignition switch off*2
11 to 14 V*3
10.5 to 16 V*4
R16-2 (ACC) - R16-17 (GND) Ignition switch ACC 11 to 14 V*3
10.5 to 16 V*4



Result:
Result Proceed to
OK A
NG (w/o Stop and Start System) B
NG (w/ Stop and Start System) C



A

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

B

REPAIR OR REPLACE HARNESS OR CONNECTOR

C