The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.
Choose the model to be inspected.
| Result | Proceed to |
|---|---|
| for LHD | A |
| for RHD | B |
A
B
Disconnect the H100 radio and display receiver assembly connector.
Disconnect the H15 No. 1 stereo jack adapter assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H100-2 (US1-) - H15-9 (UDO-) | Always | Below 1 Ω |
| H100-3 (US1+) - H15-10 (UDO+) | Always | Below 1 Ω |
| H100-5 (USG1) - H15-12 (UJSS) | Always | Below 1 Ω |
| H100-2 (US1-) or H15-9 (UDO-) - Body ground | Always | 10 kΩ or higher |
| H100-3 (US1+) or H15-10 (UDO+) - Body ground | Always | 10 kΩ or higher |
| H100-5 (USG1) or H15-12 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H100 radio and display receiver assembly connector.
Disconnect the H107 No. 1 stereo jack adapter assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
| *b | Front view of wire harness connector
(to No. 1 Stereo Jack Adapter Assembly) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H100-2 (US1-) - H107-2 (UD0-) | Always | Below 1 Ω |
| H100-3 (US1+) - H107-3 (UD0+) | Always | Below 1 Ω |
| H100-5 (USG1) - H107-5 (UJSS) | Always | Below 1 Ω |
| H100-2 (US1-) or H107-2 (UD0-) - Body ground | Always | 10 kΩ or higher |
| H100-3 (US1+) or H107-3 (UD0+) - Body ground | Always | 10 kΩ or higher |
| H100-5 (USG1) or H107-5 (UJSS) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG