The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during compressor and magnetic clutch removal/installation are shown below.
1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16400
2.REMOVE RADIATOR ASSEMBLY
16361A
3.REMOVE V-RIBBED BELT
88703
4.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the discharge hose sub-assembly from the compressor and magnetic clutch.
Remove the O-ring from the discharge hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88704
5.DISCONNECT SUCTION HOSE SUB-ASSEMBLY
Remove the bolt and disconnect the suction hose sub-assembly from the compressor and magnetic clutch.
Remove the O-ring from the suction hose sub-assembly.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
6.REMOVE COMPRESSOR AND MAGNETIC CLUTCH
Disconnect each connector.
Disengage each clamp.
| *a | Bracket |
|
Bolt |
|
Nut |
Remove the 2 bolts and 2 nuts, and separate the bracket.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor and magnetic clutch.