The grille shutter of the radiator shutter sub-assembly may only half open/close when dirty due to foreign matter, snow, mud, etc.
Before performing troubleshooting, change the grille shutter control mode to maintenance mode.
Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
If the radiator shutter assembly has been replaced with a new one, perform initialization and change the grille shutter control mode.
Click hereEngine / Hybrid System>A25A-FXS, A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
According to the display on the GTS, change the grille shutter control mode from normal mode to maintenance mode.
| Tester Display |
|---|
| Switch Grille Shutter Control Mode |
| Proceed to |
|---|
| NEXT |
NEXT
Check the area around the shutters and the links of the grille shutter for foreign matter and ice.
The radiator shutter sub-assembly is free of foreign matter and ice.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
According to the display on the GTS, perform initialization (nominal torque).
| Tester Display |
|---|
| Grille Shutter Initialization |
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, operate the grille shutter by performing an Active Test and remove any foreign matter.
When foreign matter is jammed with the grille shutter open, perform a close operation. When foreign matter is jammed with the grille shutter closed, perform an open operation.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Control the Grille Shutter | Control the swing grille actuator assembly | 0% (open) to 100% (close) | Perform this test when the following conditions are met:
·
Ignition switch ON. ·
Auxiliary battery voltage is 10.5 to 16 V. |
| Tester Display |
|---|
| Control the Grille Shutter |
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, change the grille shutter control mode from maintenance mode to normal mode.
| Tester Display |
|---|
| Switch Grille Shutter Control Mode |
Read the value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Grille Shutter Control Mode | Grille shutter control mode status | Normal or Maintenance | Normal: Normal mode
Maintenance: Maintenance mode |
- |
| Tester Display |
|---|
| Grille Shutter Control Mode |
Normal is displayed.
| Proceed to |
|---|
| NEXT |
NEXT
Remove any foreign matter and/or ice from the area around the shutters and the links of the grille shutter.
| Proceed to |
|---|
| NEXT |
NEXT