Front Wheel Alignment
Suspension
ADJUSTMENT
1. INSPECT TYRE
2. INSPECT VEHICLE HEIGHT
NOTICE:
Before inspecting the wheel alignment, adjust the vehicle height to the specification.
(a) Press down on the vehicle several times to stabilise the suspension.
-
(b) Measure the distance to the ground from points A and B for the front and C and D for the rear.
-
(c) Subtract dimension B from A for the front and D from C for the rear and compare the results to the table.
Measuring point:
A:
Ground clearance of front wheel centre
B:
Ground clearance of lower suspension arm No. 2 set bolt centre
C:
Ground clearance of rear wheel centre
D:
Ground clearance of strut rod set bolt centre
If the vehicle height is not as specified, adjust the height by pressing down on the vehicle several times to stabilise the suspension.
-
3. INSPECT TOE-IN
4. ADJUST TOE-IN
(a) Release the rack boot set clips.
-
(b) Loosen the tie rod end lock nuts.
-
(c) Turn the right and left rack ends by an equal amount to adjust the toe-in to the centre value.
-
(d) Ensure the length of the right and left rack ends are approximately the same.
Standard difference:
0 +/- 1 mm (0 +/- 0.039 in.)
-
(e) Tighten the tie rod end lock nuts.
Torque:
55.5 N*m
(566 kgf*cm,
41 ft.*lbf)
-
(f) Place the boots on the seats and install the clips.
HINT:
Ensure the boots are not twisted.
-
5. INSPECT WHEEL ANGLE
(a) Turn the steering wheel to the left and right full lock positions, and measure the turning angle.
If the angles are not as specified, check and adjust the right and left rack end lengths.
-
6. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
(a) Install the camber-caster-kingpin gauge or place the front wheels on the centre of the wheel alignment tester.
-
(b) Inspect the camber, caster and steering axis inclination.
If the camber and caster are not as specified, adjust them.
If the steering axis inclination is not as specified after the camber and caster have been correctly adjusted, check the steering knuckle and front wheel for distortion or looseness.
-
7. ADJUST CAMBER AND CASTER
NOTICE:
After the camber has been adjusted, inspect the toe-in.
(a) Loosen the camber adjusting cam nut and camber adjusting cam bolt.
-
(b) Turn the No. 1 camber adjusting cam and No. 2 camber adjusting cam in both directions, and adjust the camber and caster to the centre value.
-
(c) The camber and caster should be as close as possible to the centre value.

-
(d) How to read adjustment chart (using examples).
(1) Find the wheel alignment standard value.
(2) Mark the selected standard value on the adjustment chart. 0°00' (0.00°)
(3) Mark the alignment value measured when the vehicle is unloaded on the adjustment chart. 0°10' (0.17°)
-
