2008-2009 Hilux TRD · Service Manual Brake

Brake Booster Pipe

Brake

COMPONENTS
REMOVAL
1. DISCONNECT SUPERCHARGER VACUUM HOSE
(a) Remove the retaining clip and disconnect the supercharger vacuum hose from the brake booster pipe assembly.
-
(b) Remove the nut attaching the pipe assembly to the vehicle.
-
2. DISCONNECT BRAKE BOOSTER VACUUM HOSE
(a) Remove the retaining clip and disconnect the brake booster vacuum hose from the brake booster pipe assembly.
-
(b) Remove the nut attaching the pipe assembly to the vehicle.
-
3. REMOVE BRAKE BOOSTER VACUUM PIPE ASSEMBLY
(a) Remove the brake booster pipe assembly from behind the wire harness.
-
INSTALLATION
HINT:
If the brake booster pipe assembly is replaced, remove the retainers supplied with the pipe and discard. Fit new retainers for the TRD application, ensuring they are correctly orientated with the stud holes down.
1. INSTALL BRAKE BOOSTER VACUUM PIPE ASSEMBLY
(a) Install the brake booster pipe assembly behind the wire harness.
-
2. CONNECT BRAKE BOOSTER VACUUM HOSE
(a) Install the nut attaching the brake booster pipe assembly to the vehicle.
Torque:
12 N*m (122 kgf*cm, 13 ft.*lbf)
-
(b) Connect the brake booster vacuum hose to the pipe assembly and install the retaining clip.
-
3. CONNECT SUPERCHARGER VACUUM HOSE
(a) Install the nut attaching the brake booster pipe assembly to the vehicle.
Torque:
12 N*m (122 kgf*cm, 13 ft.*lbf)
-
(b) Connect the supercharger vacuum hose to the pipe assembly and install the retaining clip.
-