Rear Bumper
Exterior
COMPONENTS

REMOVAL
1. REMOVE REAR BUMPER BAR
(a) Disconnect the 2 licence plate light connectors.
-
(b) Detach the 4 clamps.
-
(c) Remove the 4 bolts and rear bumper bar.
-
DISASSEMBLY
1. REMOVE REAR BUMPER ARM LH
(a) Remove the 2 bolts and bumper arm.
-
2. REMOVE REAR BUMPER ARM RH
HINT:
Use the same procedures described for the LH side.
3. REMOVE LICENCE PLATE LIGHT ASSEMBLY
(a) Detach the 4 claws and remove the 2 lights.
-
4. REMOVE REAR BUMPER PLATE
(a) Apply protective tape along the bumper.
-
(b) Insert a piano wire between the rear bumper plate and bumper.
-
(c) Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.
-
(d) Pull the piano wire and cut through the double-sided tape attaching the plate to the bumper body.
-
(e) Remove the rear bumper plate.
-
REASSEMBLY
1. INSTALL REAR BUMPER PLATE
(a) Clean the rear bumper surface.
(1) Using a heat light, warm the rear bumper surface and remove any remaining double-sided tape.
(2) Wipe off any tape adhesive residue with cleaner.
-
(b) Clean the rear bumper plate. (If reusing the plate)
(1) Using a heat light, warm the plate surface and remove any remaining double-sided tape.
(2) Wipe off any tape adhesive residue with cleaner.
(3) Apply new double-sided tape to the plate in the original locations.
-
(c) Install the rear bumper plate.
(1) Using a heat light, warm the rear bumper and plate.
(2) Remove the release paper from the double sided tape.
HINT:
After removing the release paper, keep the exposed adhesive free from foreign matter.
(3) Install the rear bumper plate.
-
2. INSTALL LICENCE PLATE LIGHT ASSEMBLY
(a) Attach the 4 claws to install the 2 lights.
-
3. INSTALL REAR BUMPER ARM LH
(a) Install the arm with the 2 bolts.
Torque:
45 N*m
(459 kgf*cm,
33 ft.*lbf)
-
4. INSTALL REAR BUMPER ARM RH
HINT:
Use the same procedures described for the LH side.
INSTALLATION
1. INSTALL REAR BUMPER BAR
(a) Install the bumper with the 4 bolts. Do not tighten.
-
(b) Align the bumper as shown in the illustration and tighten the bolts.
Torque:
45 N*m
(459 kgf*cm,
33 ft.*lbf)
-
(c) Attach the 4 licence plate light clamps.
-
(d) Connect the 2 connectors.
-