Front Door Black OUT Tape
Exterior
COMPONENTS
HINT:
Front door black out tape is not fitted to vehicles painted black.

REMOVAL
1. REMOVE FRONT DOOR GLASS RUN
(a) Fully lower the front door glass.
-
(b) Remove the front door glass run along the rear edge of the front door frame.
-
2. REMOVE FRONT DOOR BLACK OUT TAPE
(a) Use a heat gun to warm the top edge of the front door black out tape. (1)
NOTICE:
Do not overheat the tape.
-
(b) Peel back the corner of the tape and move the heat gun along the tape to warm the area ahead of where it is being removed (2).
CAUTION:
Take care not to burn your fingers.
-
(c) Continue to slowly remove the tape from the door frame surface, while moving the heat gun along the tape (3).
-
(d) Clean any residual from the door frame surface.
-
INSTALLATION
NOTICE:
The front door black out tape installation area must be clean.
1. PREPARE VEHICLE
(a) Clean the front door frame with a suitable cleaner, removing all traces of dirt, wax and grease. Dry thoroughly.
HINT:
Pay particular attention to the recesses and lower corner where dirt can build-up.
-
(b) Wipe the panel where the tape is to be affixed with an alcohol wipe or equivalent.
HINT:
Do not clean the area with a wax and grease remover or similar as these products leave a residue.
-
2. INSTALL FRONT DOOR BLACK OUT TAPE
(a) Peel back 30 - 50 mm from the top corner of the backing paper.
-
(b) Place the decal on the door frame, aligning the upper corner notch with the top edge of the door frame.
-
(c) Beginning from the top, smooth the decal toward the bottom using a rubber applicator, while peeling back the backing paper.
NOTICE:
Work out any air bubbles as you go.
-
(d) Inspect the decal for air bubbles and work them from the tape to the closest edge.
-
(e) Using the applicator, work the tape into the window glass side recess and around the door frame edge in several passes (1, 2).
HINT:
Start in the centre and work up and down the door frame.
-
(f) Using the applicator, work the tape around the door frame rear edge in several passes (1, 2, 3).
HINT:
Start in the centre and work up and down the door frame.
-
3. INSTALL FRONT DOOR GLASS RUN
(a) Install the front door glass run along the rear edge of the front door frame.
-
(b) Raise the front door glass.
-