Home › ENGINE ยท 5L-E › COOLING › WATER PUMP

WATER PUMP > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag activation.



2. REMOVE NO. 1 ENGINE UNDER COVER (for 4WD)


A121844
  1. Remove the 8 bolts and under cover.



3. DRAIN ENGINE COOLANT

NOTICE:
Do not remove the radiator reservoir cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.



    A114241
  1. Remove the reservoir cap and, using a wrench, remove the vent plug.



  1. Loosen the cylinder block drain cock plug and the radiator drain cock plug and then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



    A114242E01



4. DISCONNECT RADIATOR HOSE INLET


5. DISCONNECT RADIATOR HOSE OUTLET


6. REMOVE FAN SHROUD


    A114244
  1. Remove the 3 bolts and oil reservoir.

  1. Disconnect the No. 1 and No. 2 water by-pass hoses from the tank upper and lower.

  1. Remove the bolt and radiator reservoir.

  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the vane pump V belt, cooler compressor V belt and fan and generator V belt (Click here).

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



7. REMOVE TIMING BELT
  1. Remove the timing belt (Click here).



8. REMOVE WATER PUMP ASSEMBLY


    A031001E01
  1. Remove the 6 bolts and tension spring bracket.

  1. Remove the water pump and gasket.