Home › TRANSMISSION · A750F AUTOMATIC TRANSMISSION › AUTOMATIC TRANSMISSION SYSTEM (for 1KD-FTV)

DTC    P0560    System Voltage

for Preparation Click here


DESCRIPTION

The battery supplies power to the TCM even when the ignition switch is off. This power allows the TCM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the TCM data is cleared and the TCM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the TCM will illuminate the MIL and store the DTC.

DTC Code
DTC Detection Condition
Trouble Area
P0560
Open in the TCM back-up power source circuit (1 trip detection logic).
  1. Open in back-up power source circuit
  2. TCM

HINT:
If DTC P0560 is stored, the TCM does not store other DTCs.


WIRING DIAGRAM


C156221E01


INSPECTION PROCEDURE

1.CHECK TCM (BATTERY, GROUND)


    C193057E02
  1. Disconnect the T17 and T19 TCM connectors.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    T17-5 (BATT) - T19-1 (E1)
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    T19-1 (E1) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (TCM - BATTERY, GROUND)
OK

REPLACE TCM