DTC 12 Crankshaft Position Sensor Circuit Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| 12 | No TDC signal to ECM at 400 rpm or more |
|

| 1.INSPECT CRANKSHAFT POSITION SENSOR |
![]() |
Check the crankshaft position sensor installation.
Disconnect the crankshaft position sensor connector.
Measure the resistance of the crankshaft position sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | Cold | 19 to 32 Ω |
| 1 - 2 | Hot | 24 to 37 Ω |
|
| ||||
| OK | |
| 2.CHECK ECM (TDC, NE SIGNAL) |
![]() |
While cranking or idling, measure the waveform according to the value(s) in the table below.
| Tester Connection | Specified Condition |
| E23-17 (TDC+) - E23-16 (TDC-) | Correct waveform is as shown |
| E23-19 (NE+) - E23-18 (NE-) | Correct waveform is as shown |
|
| ||||
| NG | |
| 3.CHECK WIRE HARNESS (ECM - CRANKSHAFT POSITION SENSOR) |
![]() |
Disconnect the C4 crankshaft position sensor connector.
Disconnect the E23 ECM connector.
Measure the resistance of the wire harness side connectors.
| Tester Connection | Specified Condition |
| C4-1 (+) - E23-17 (TDC+) | Below 1 Ω |
| C4-2 (-) - E23-16 (TDC-) | Below 1 Ω |
| E23-17 (TDC+) - E23-16 (TDC-) | 10 kΩ or higher |
| E23-17 (TDC+) - Body ground | 10 kΩ or higher |
| E23-16 (TDC-) - Body ground | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||