Home › ENGINE · 5L-E › ENGINE CONTROL SYSTEM › ECD SYSTEM

DTC    42    Vehicle Speed Sensor Signal Circuit Malfunction

for Preparation Click here


DESCRIPTION

The vehicle speed sensor outputs a 4-pulse signal for every revolution of the rotor shaft, which is rotated by the transmission output shaft via the driven gear. After this signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter, it is then transmitted to the ECM. The ECM determines the vehicle speed based on the frequency of these pulse signals.

G036461E02


DTC No.
DTC Detection Condition
Trouble Area
42
All conditions below are detected continuously for 8 sec. or more:
  1. Vehicle speed signal: 0 km/h (0 mph)
  2. Engine speed: 2,000 to 3,300 rpm
  3. Engine coolant temperature: 70°C (158°F) or more
  4. Accelerator pedal opening angle: 60% or more
  1. Open or short in vehicle speed sensor circuit
  2. Vehicle speed sensor
  3. Combination meter
  4. ECM

WIRING DIAGRAM


A119980E03


INSPECTION PROCEDURE

1.CHECK SPEEDOMETER (OPERATION)
  1. Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.

    OK:
    The speedometer operates normally according to vehicle speed.

    HINT:
    The vehicle speed sensor is operating normally if the speedometer display is normal.



NG
CHECK SPEEDOMETER CIRCUIT
OK


2.CHECK ECM (SP1 VOLTAGE)


    A110539E03
  1. Move the shift lever to the neutral position.

  1. Jack up the vehicle.

  1. Turn the ignition switch ON.

  1. Measure the voltage between the terminals SP1 and E1 of the ECM connector when the wheel is turned slowly.

    OK:
    Tester Connection
    Specified Condition
    E20-9 (SP1) - E23-14 (E1)
    Correct waveform is as shown



OK
REPLACE ECM
NG


3.CHECK WIRE HARNESS (COMBINATION METER - ECM)


    A121702E01
  1. Disconnect the E20 ECM connector.

  1. Disconnect the C8 combination meter connector.

  1. Measure the resistance of the wire harness side connectors.

    Standard resistance:
    Tester Connection
    Specified Condition
    C8-6 - E20-9 (SP1)
    Below 1 Ω
    E20-9 (SP1) - Body ground
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE ECM