ECD SYSTEM > CHECK MODE PROCEDURE |
| CHECK MODE PROCEDURE |
![]() |
Make sure that the vehicle is in the following condition:
Battery voltage is 11 V or more.
Shift lever is on N.
A/C switch is off.
Turn the ignition switch OFF (if on).
Connect the intelligent tester to the DLC3.
Turn the ignition switch ON and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / Check Mode.
![]() |
Make sure the MIL blinks as shown in the illustration.
Start the engine (the MIL should turn off).
Simulate the conditions of the malfunction described by the customer.
Check the DTC(s) and freeze frame data using the tester.
After checking the DTC, inspect the applicable circuits (Click here).