AUTOMATIC TRANSMISSION SYSTEM > MECHANICAL SYSTEM TESTS |
| STALL SPEED TEST |
Connect the intelligent tester to the DLC3.
Run the vehicle until the ATF temperature has reached 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning OFF.
Chock all 4 wheels.
Set the parking brake and keep the brake pedal depressed firmly with your left foot.
Move the shift lever to the D position.
Depress the accelerator pedal as much as possible with your right foot.
Read the engine rpm (stall speed) and release the accelerator pedal immediately.
| Test Result | Possible Cause |
| Stall speed is lower than standard value |
|
| Stall speed is higher than standard value |
|
| SHIFT TIME LAG TEST |
Connect the intelligent tester to the DLC3.
Run the vehicle until the ATF temperature has reached 50 to 80°C (122 to 176°F).
Allow the engine to idle with the air conditioning OFF.
Set the parking brake and keep the brake pedal depressed firmly.
Check the D range time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to D and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and calculate the average time of the 3 tests.
Check the R range time lag.
Move the shift lever to N and wait for 1 minute.
Move the shift lever to R and measure the time until the shock is felt.
Repeat the 2 procedures above 3 times, and calculate the average time of the 3 tests.
| Test Result | Possible Cause |
| D range time lag exceeds standard value |
|
| R range time lag exceeds standard value |
|