ELECTRONIC CONTROLLED AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| MEASURE LINE PRESSURE |
![]() |
Warm up the ATF.
Remove the test plug from the front side of the transmission case and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check idling speed.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal as much a possible. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
Perform the measure line pressure test again with the shift lever on R.
| Condition | Shift Lever on D | Shift Lever on R |
| Idling | 370 to 450 kPa (3.8 to 4.6 kgf/cm2, 54 to 65 psi) | 480 to 590 kPa (4.9 to 6.0 kgf/cm2, 70 to 86 psi) |
| Stall | 1060 to 1190 kPa (10.8 to 12.1 kgf/cm2, 154 to 173 psi) | 1430 to 1750 kPa (14.6 to 17.8 kgf/cm2, 207 to 254 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|