AUTOMATIC TRANSMISSION SYSTEM > HYDRAULIC TEST |
| MEASURE LINE PRESSURE |
![]() |
Warm up the ATF.
Remove the test plug from the front side of the transmission case and connect SST.
Fully apply the parking brake and chock the 4 wheels.
Start the engine and check idling speed.
Keep your left foot firmly on the brake pedal and move the shift lever to D.
Measure the line pressure when the engine is idling.
Depress the accelerator pedal as much as possible. Quickly read the highest line pressure reading when the engine speed reaches stall speed.
Perform the measure line pressure test again with the shift lever on R.
| Condition | Shift Lever on D | Shift Lever on R |
| Idling | 382 to 441 kPa (3.9 to 4.5 kgf/cm2, 55 to 64 psi) | 735 to 834 kPa (7.5 to 8.5 kgf/cm2, 107 to 121 psi) |
| Stall | 932 to 1,069 kPa (9.5 to 10.9 kgf/cm2, 135 to 155 psi) | 1,334 to 1,667 kPa (13.6 to 17.0 kgf/cm2, 194 to 242 psi) |
| Problem | Possible Cause |
| Measured values at all positions are higher than specified |
|
| Measured values at all positions are lower than specified |
|
| Pressure is low when shift lever is on D only |
|
| Pressure is low when shift lever is on R only |
|